12/13/2023 0 Comments Schlage be469You name it, I've tried it with my schlage BE469 and with my two Alfred z-wave locks. Locks were the reason I lost sleep at night. Happy to buy a few aotechs but I hate to throw away perfectly good hardware if it can be repurposed.ĭev:197 12:58:12.955 am infoFront door lock battery is 76%ĭev:197 12:58:12.952 am debugBatteryReport: BatteryReport(batteryLevel:76)ĭev:197 12:58:12.933 am debugparse: zw device: 10, command: 9881, payload: 00 80 03 4C, isMulticast: falseĭev:197 10:22:17.749 pm infoFront door lock was locked by thumb turn ĭev:197 10:22:17.745 pm debugalarmv2.AlarmReport: AlarmReport(alarmLevel:1, alarmType:21, eventParameter:, numberOfEventParameters:0, zensorNetSourceNodeId:0, zwaveAlarmEvent:1, zwaveAlarmStatus:255, zwaveAlarmType:6)ĭev:197 10:22:17.626 pm debugparse: zw device: 10, command: 9881, payload: 00 71 05 15 01 00 FF 06 01 00, isMulticast: falseĭev:197 06:57:04.516 pm warnskipped alarmType:5ĭev:197 06:57:04.513 pm debugalarmv2.AlarmReport: AlarmReport(alarmLevel:0, alarmType:5, eventParameter:, numberOfEventParameters:0, zensorNetSourceNodeId:0, zwaveAlarmEvent:2, zwaveAlarmStatus:255, zwaveAlarmType:7)ĭev:197 06:57:04.433 pm debugparse: zw device: 10, command: 7105, payload: 05 00 00 FF 07 02 00 00, isMulticast: false Here is the logging from the front lock.is there a way to get additional logging from it? This doesn't seem like enough communication to cause the drain so maybe there is additional logging I'm not aware of I need to pull.Īlso I have probably 6 wink v1 hubs.lol an angry mob of friends returned them to me after the Wink debacle that I could use as repeaters if that would help. For years it was a soldier but even on Wink2 it began to chew up batteries about a year ago.įront Lock firmware version is 6.8. Doing everything including lock/unlocking it by hand so I'm not even using the lock's motor right now. I looked at perhaps the 'high power mode' being an issue (made sure the bolt had no resistance) but as an experiment I am not doing any automation with the lock at the moment. Everything is instantaneous so far and whether I'm using Alexa or Hubitat dashboards I haven't had a single issue issuing commands to either lock as far as I've observed. The hubitat is on the other side of the house but I have NO issues communicating with the lock. There is a Jasco/GE zwave dimmer switch literally 6 inches away from the front lock. I put fresh batteries in my front and back locks a week ago and the back lock is still showing 100% and the front lock has started to fall off a cliff.down to 76%. I have been diligent & read all the threads here including the discussions about buying the aotech zwave range extenders.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |